DIY Handy Bag Holder
Sturdy cotton or cotton blend fabric:
22″ long and 9 1/2″ wide
1″ wide ribbon, 9″ length
1/2″ wide elastic, 12″ length
2 small safety pins
Cut the fabric to 22″ long and 9 1/2″ wide (can be adapted to your specifications)
Cut the fabric if there are any folds, such as at one end of the fabric piece.
Zigzag or finish all edges with a serger
As shown, but do NOT sew any end seams together
Leave ends open, one will be for the loop to hang and one will for the elastic Turn inside out and turn sideways (for better words and press seam open)
Turn right side and press neatly.
Cut 1/4″ ribbon 9″ long
Loop the ribbon and slide inside one end of the sleeve or bag with the ends crossed. Stitch across at 5/8″. Double stitch and back stitch over ribbon.
Cut 1/2″ elastic 12″ long. Attach a safety pin to each end
At the other end of the sleeve, or bag, fold down 5/8″ and press
Sew the seam right against the edge of the fabric LEAVING AN OPENING OF 1 1/2″. Back stitching at the edges of the opening,
Feed the elastic through the seam, not allowing the second safety pin to go through also.
Take off the pins and sew the elastic ends together, using care they are not twisted but facing the same way.
Tuck the elastic ends into the seam.
And sew the fabric over to close up the seam.
Turn inside out and pull out the ribbon loop. Pull corners out using the end of a pencil or being very careful with a seam ripper.
Press again and put in a bag to let those you are gift this to know exactly what the purpose of this wonderful recycle bag is for!
Copyright Carrie Groneman, A Mother’s Shadow, 2015
Recognize a blessing and be a blessing today
For More On This Topic:
Waste Not – Want Not, click HERE
Does the Brand Define YOU, click HERE